Hi --

Just an update on my experience loading the new Lodi software from 7.10.25. As in my post below the Lodi-Start has now been successfully loaded for MacOS once the 'JRE full' version of the Java software from the Bellsoft website was selected.

I have, however, had to take the Lodi-Rektor update off the system and revert via the 'expert mode' to the prior version (03.04.09). The Rector update caused the HOm section of my layout to go offline. Very strange behavior -- it would power up for a few seconds then power down. I tried swapping out the Booster (it has a dedicated Booster) but this did not fix it. The only solution was to revert to the original software version for the Rector. The CV Programmer loaded fine and is working great.

I hope this feedback is of use to the team.

My extensive layout (OO/HOm) is fully operated by LoDi with iTrain on a MacOS with 4 Boosters and multiple detector and switch modules.

Regards Andy