Hi,
I have an issue when trying to configure a LoDi 8-GBM via LoDi-ProgrammerFX. I can enter the adderss of the unit (in this case 18), but LoDi-ProgrammerFX still reports it as a RM16+ even after a re-scan.

I have managed to configure 2 other 8-GBM's correctly so not sure why this on is not working correctly.

Any ideas how to resolve?

Best Regards,
Gordon_D

Moin Moin,

das klingt danach, dass die Netzwerkkabel nicht richtig angeschlossen sind. Eine andere Möglichkeit wäre das nicht die richtige Anzahl von Geräten je Bus richtig eingestellt ist

Gruß Helge

Andreas,
Applogies, not been able to take the screen shots until now.
Please advise if any other infor is required

[[File:S88 bus 1 of 2.gif|none|fullsize]][[File:S88 Bus 2 of 2.gif|none|fullsize]][[File:S88-CommLX 1 of 2.gif|none|fullsize]][[File:S88-CommLX 2 of 2.gif|none|fullsize]]

Best Regards,
Gordon